Select Page

Sovol SV02 3D Printer Unboxing and First prints

Sovol SV02 3D Printer Unboxing and First prints

Written by David

September 22, 2020

Hey, Karl here. Back in September of 2019, I reviewed the Sovol SV01 printer. I had a very good experience and still recommend it to this day.

 .

Fast forward a year and Sovol is back with a new version, the SV02. The SV02 is a dual extruder single nozzle printer. This will be my 3rd dual extruder 3D printer.

 .

The first 2 I did not have a very good experience with. Sovol sent over this printer at no charge for review purposes. I am going to share my experience a little differently this time. Instead of 1 long article, I will break it up into bite-size pieces.

 .

In this one, I will share my initial impressions and first prints. The new 3D printers I have been seeing have not been very exciting lately. They all basically have the same features and only minor differences and the SV02 […]

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *

You May Also Like…

Pin It on Pinterest

Share This

Share this post with your friends!

Shares