Select Page

Iran Develops 3D Printer to Produce Fibre-Reinforced Composites

Iran Develops 3D Printer to Produce Fibre-Reinforced Composites

Written by David

June 29, 2020

Researchers at an Iranian university have designed and built the largest 3D printer to produce fibre-reinforced composites in various industries.

 .

A group of researchers from the faculty of textile engineering of Isfahan University of Technology have succeeded in domesticising the production technology of 3D printers equipped with simultaneous fibre supply systems. This is the country’s largest system that uses two-layered technology to produce composite-polymer samples. Dr Hossein Hassani, a faculty member of Isfahan University of Technology said due to the low cost, this 3D printing method is becoming one of the most important methods of manufacturing industrial parts. However, the parts produced with this method have lower strength than other common methods, he said. “The results of the research showed that by using the simultaneous feeding of fibres during the three-dimensional printing process, the strength of the three-dimensional printed parts can be increased.” He also named some applications of […]

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *

You May Also Like…

Pin It on Pinterest

Share This

Share this post with your friends!

Shares