Select Page

DMG Mori launched the LASERTEC 6600 system to 3D print 4 meter parts

DMG Mori launched the LASERTEC 6600 system to 3D print 4 meter parts

Written by Paul

December 30, 2020

At Formnext 2019 many were in awe seeing the very large LASERTEC 125 DED hybrid system from DMG Mori .

 .

This year there was no physical formnext but if DMG Mori could have shown its newest 3D printer it would have dwarfed it. The LASERTEC 6600 DED hybrid system is a behemoth with up to 1,040 mm on the X-axis, -280 mm to +330 mm on the Y-axis, 3,890 mm on the Z-axis. Yes you read correctly: that’s 4 meters (a bit more than 12 feet) on the Z axis. DMG Mori’s the LASERTEC 4300 DED hybrid This means it can be used to make parts that are as large as Φ1,010 mm × 3,702 mm. Something this huge is a bit hard to miss, but apparently, almost everyone did miss it, since it was released in August of this year and the only portal to report it was Seisanzai Japan. In fact, DMG Mori also released another machine, not quite as large but not so small either: the LASERTEC 4300 DED hybrid. This clearly indicates that the company really believes in its DED hybrid AM business. This machine can be used to make large parts up to Ø […]

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *

You May Also Like…

Pin It on Pinterest

Share This

Share this post with your friends!

Shares