Select Page

Anycubic Photon Mono review: Anycubic holds your hand for resin 3D printing beginners

Anycubic Photon Mono review: Anycubic holds your hand for resin 3D printing beginners

Written by Paul

December 20, 2020

When Anycubic said they would be releasing a slew of new MSLA printers that use monochrome LCDs, I had assumed they’d take older models, swap the screen, and then call it a day, but I was wrong.

 .

The Photon Mono is one of three new printers from Anycubic, the Mono SE, Mono, and the Mono X.

 .

The big changes are the monochrome LCDs, which allow for much faster layer times of under 2 seconds and a longer lifespan than RGB counterparts. Resin 3D printing is about to go through a major change, and Anycubic is embracing it in a big way. Bottom line: Anycubic has released a resin printer which has no serious defects, isn’t a pain to use and has a very easy to use slicer with preconfigured profiles for its own printers, holding your hand all the way. Great detail, even at 0.15mm layers Speedy, >2 second […]

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *

You May Also Like…

Pin It on Pinterest

Share This

Share this post with your friends!

Shares