Select Page

3D Printed Chain Lifts Car Off the Ground | HP Multi Jet Fusion™ Technology | HP

Written by Paul

January 14, 2019

“The new HP Multi Jet Fusion™ Technology can produce parts up to 10 times faster(1), with strength! To prove how strong the parts can be, HP 3D printed a chain link in about 30 minutes using HP Multi Jet Fusion™ Technology. The link weighs 1/4 pound and can lift up to 10,000 pounds. To put its strength to the test, HP’s Steven Nigro, senior vice president, Graphics and Inkjet Solutions Business, had the team use it to lift a 1995 Avalon right into the air.”

0 Comments

Submit a Comment

Your email address will not be published. Required fields are marked *

You May Also Like…

Pin It on Pinterest

Share This

Share this post with your friends!

Shares